Wheelchair User Manual Tutorial – Step-by-Step Guide

Place the wheelchair on a flat [music] surface. Hold the back rest tube with one hand and the seat cushion with the other and push the wheelchair away from the [music] floor until it is fully open. Make sure the locking clips are fastened. [music] Installing the controller. Insert the end of the controller's telescoping [music] tube into the hole in the vehicle's right hand armrest tube. Then turn the plum knob to lock into place. Make sure [music] to straighten before tightening. Connect and tighten these two cables together. Installing the anti-tip wheels. First, [music] pull out the pin. Then, put into the hole and fasten the pin. Lock brakes. Pull lever forward [music] to lock wheel from moving. Push lever back to enable movement. Armrests. Push red button to lift the armrest. Installing [music] the battery slide battery pack into the track under seat. Snap the malor red cable into the larger red cable. Charging the battery in two ways. Option A, remove the battery pack from beneath the seat and plug [music] in the charger to it after powering off chair. Option B, notice the flashlight beneath the controller at the end of the armrest. Pull out the flashlight from the socket. Plug the charger into the charging input in the exact place [music] where the flashlight was inserted. To use the wheelchair in neutral mode, first turn off the power. Pull red lever backwards [music] to disable electric use and enable manual mode. Controller features on off button. [music] Speed down button. Speed up button. Horn button. Joystick. Battery indicator. Accurate speed kilome per hour. Wheelchair pattern. Trip mileage [music] kilm. Speed indicator five gears. Push joystick forward to move wheelchair ahead. Pull joystick backward to move wheelchair in reverse. Move joystick left to rotate. Move joystick right to rotate wheelchair. Emergency [music] brake system. Pull the joystick back to slow down and stop. Or press the power button to [music] remove power from the wheelchair. Pairing and using the remote controller. Press the onoff button and the remote control should automatically pair with the wheelchair indicated by a green flashing light. On, off button, horn button, forward motion, reverse motion, left turn, [music] right turn, emergency brake. Pull the joystick towards the downward position. Press the power button to remove power [music] from the wheelchair. To fold the wheelchair, first unlock the locking clip, then push the wheelchair down to the floor and carry the wheelchair with ease.